Item ended: 4" X 6" DALE EARNHARDT JR #88 W/ SIGNATURE VINYL DECAL (details below)

4" X 6" DALE EARNHARDT JR #88 W/ SIGNATURE VINYL DECAL

$3.50
Listing ended Tue, May 8, 9:34 pm EDT

92 Bought
Watcher count unavailable

Seller reliablesignsinc has 98.9% + feedback, 2076 total feedback on eBay

View reliablesignsinc's other items

VINYL DECALS!! This is a white Dale Earnhardt #88 with signature decal measuring approx. 6" tall x 4" wide. We have other colors and listings available as well. Available Colors Are: White, Black, Blue, Green, Brown, Orange, Gold, Red and Yellow. Please advise what color you want in the notes section of checkout. If no color is indicated, then decal will be white. FREE SHIPPING!!!!!! Please ask any questions before bidding. Thanks for looking and please check out our other listings. NOTE - There is no background on this decal. All items that are sold here are made of Computer Die-Cut Exterior Vinyl. They are intended for use on the exterior of any mostly flat semi-non-porous surface. These are most commonly purchased for the back glass, side glass or windshield of vehicles. They will, however, apply to any flat, clean surface. Some other examples for other surfaces are snow/skate/surf boards, helmets, walls, toolboxes, laptops, etc. These decals will last with proper care for approx. 7-10 years with NO peeling, cracking or fading! All decals are shipped masked and ready for application. APPLICATION INSTRUCTIONS IMPORTANT, you'll just need a clean surface to apply your decal onto. Simply use a paper towel and a good cleaner like Windex or alcohol to clean your surface with. 1) Line the decal up first to make sure it fits in your desired space. 2) Peel the backing off. 3) After the backing is off, carefully place the decal where you want it, then use a squeegee (a credit card will work for this) and run over the decal with added pressure for it to stick to your surface. Start in the middle of the decal and work out in all angles. This will get all the air bubbles out. 4) Now, begin to peel the application tape off the decal. Start from one end and peel away from the surface at 180 degrees (pulling it back over itself very slowly). If the decal starts to peel off, STOP, and apply more pressure to the decal before you continue to remove the application tape. 5) Finally, just go over the decal with your hand and smooth it down. You now have a nice looking vinyl graphic! If bubbles appear in your decal, simply pop them with a needle or sharp edge, being careful not to cut the decal. TIP: When positioning the graphic, try putting a piece of masking tape along the top of it. Then use it as a hinge and lift the decal up to pull the backing off. Now just lay the decal down onto the surface, and rub on. Thanks for looking and please check out our other listings.